Fuzziness softens based on color, Feather softens based on geometry
Fuzziness, in Color Range, controls tolerance in color-similarity space. It doesn't just decide which pixels are in or out, it produces partial selection, gray values in the resulting mask, for pixels that are close to but not identical to your sampled hue. That gray gradient is what a smooth, natural-looking selection edge is actually made of: real partial inclusion based on how similar each pixel's color genuinely is.
Feather does something entirely different. It blurs the selection boundary in physical, spatial distance, completely ignoring what color is actually sitting on either side of that boundary. It doesn't know or care whether the edge is jagged because of real color variation in the image or because your tolerance setting was too tight, it just softens geometrically.
Why a tight Fuzziness produces a jagged edge in the first place
Set Fuzziness low and the selection becomes close to binary: a pixel is either close enough to your sampled color to count, or it isn't, with almost no gray transition zone in between. On fine or noisy detail, foliage, hair, a textured surface, that binary cutoff shows up as a jagged, aliased edge, because there's no gradual falloff to smooth the boundary the way real color similarity naturally would if you let it.
Why reaching for Feather first often makes it worse
Feathering a mask that's jagged because of tight Fuzziness treats the symptom, not the cause. It blurs the hard edge into something visually softer, but since the blur has no idea where the real color boundary actually is, it bleeds selection strength across a fixed spatial radius regardless of what's genuinely there, which shows up as a halo or a soft fringe of the wrong color exactly where the real transition should have been sharp.
The fix: raise Fuzziness first, feather only if you still need it
Widen the Fuzziness slider until the mask itself shows a real gray transition zone that follows the image's actual color detail, this is the content-aware fix, and it's usually enough on its own. Only add a small amount of Feather afterward if the composite still needs a touch of purely geometric softening on top, and keep the radius small: you're finishing the edge at that point, not doing the primary softening work.
Quick answers to a few related questions
Can raising Fuzziness too far cause its own problems?
Yes. Push it high enough and you start pulling in unrelated hues that happen to sit nearby in color space, which defeats the point of a hue-specific selection in the first place. Widen it until the transition looks natural, not further.
Is Feather the same as the Smooth option in Select and Mask?
No. Smooth rounds out a jagged selection contour's shape without blurring transparency the way Feather does. They solve different problems, a rough outline versus a hard transition, and it's worth knowing which one you actually need.
Can I feather just a saved mask instead of the live selection?
Yes, apply Gaussian Blur directly to a saved mask or channel for the same practical result as Feather, with a live preview and more direct control over the exact radius than the Feather dialog gives you.
EN
IT